Tuesday, September 21, 2010

Why is the clock on my computer starting to show the wrong time?



Answer:

Your CMOS freestyle is probably going out... Replace the battery.



Here's how:



1. Unplug your computer



2.Open your computer tower



3. look for a round silver mobile on the motherboard



4. Remove it and replace it



NOTE: Save all of your BIOS Settings because once the freestyle is out all your BIOS settings will be erased.



Also nearby have be reports of computers exploding when the battery is placed incorrectly. Place it next to the positive pole pointing upwards.
There is a small battery on the motherboard (the chief board inside the computer) that maintains the clock, among other things. This is failing and requests replacing. It's like a life-size silver watch battery-operated.
10 points for the guy above

I will also point this:

Is it possible that your GMT zone is not set up right?
Isn't it also possible that the setup file have gone wonky/ And you could log in to set up when you boot, and check the time from surrounded by there as all right? Seems like that happen to my friends' computers a lot.

miniature huskies

Why is my peak black?

My notebook blind is black. If I use a flashlight i can see what is on the screen. I enjoy tried adjusting the settings for my monitor zilch helps. The notebook is not fairly 2yrs old. It give me no warning fine one minute and black the subsequent. Can someone please give me some suggestion.


Answer:

Your backlight went out. There are no settings to fix this. I hope you are still coverred below warranty because the backlight isn't cheap nor easy to replace. Good Luck HTH.
Hi. Your pay for light is any broken or turned way down, but my guess is broken.
the backlight burned out, filch it in for service.
your backlight is fruitless take it to your local computer shop and hold it repaired.


Why is my monitor figurine jump after scrolling subsidise down?

Hi guys. i merely found this site so thought id ask you guys if you know whats up beside my crazy pc. About a hour ago the picture on the peak kept jumping upto in the region of halfway up the blind and scrolling back down and doing that over and over. Now the picture have stuxk about partially way up my monitor so the depiction of my desktop ect is really squashed but still just as cavernous. i did a system resore but it all a short time ago started again after a while. Is this likely to be a broken monitor or something else? appreciation for any help you can contribute me.


Answer:

its your graphics card do a system restore to an earlier date email me if you necessitate any more help alanmoore799@btinternet.com
Try the buttons on the monitor you might fix it form in attendance if not Go to Start/Restart and newly as windows is roughly to load Press and hold F8 for a sec or two consequently Arrow up to Return my computer to a time that worked,( Or words to that effect you will recognise it when you see it.) Press ENTER. If that won't fix it right click on an empty piece of the screen and shift into graphics properties/options you may be able to fix it from at hand by trial and error, and if that don't work the monitor may be gone.



Good Luck


Why is my LCD slow?

During gaming , my LCD is much slower than my CRT

If I am going to use this near a better video card, will it make it work faster?



ViewSonic vx910 w/ Dvi nouns


Answer:

The response time will be the biggest contributer to this. Check to make sure it's at most minuscule 6ms or lower, if it is, then check for any available drivers from the capitalist.



refresh rate = response time
What resolution are you running your LCD on? If you're running twice the resolution on your LCD that you are on your CRT, afterwards it will be slower. Also, check your response time. That tells you how vigorous your monitor is able to formulate a picture as it comes out. (8ms is around average)
Lcd's are by nature slower but you should be capable of get it to work. A better video card could comfort but like previously stated if the monitors response time and rejuvenate rate aren't that good you're probably stuck.


Why is my computer blind SO lubricant?

I tried restoring it & it turns mundane & then it still reverts to individual fat next to black covering on each side of the eyeshade, looking similar to a horizontal version of a widescreen DVD. I even did a virus scan & it still is acting funny. How can I take my computer screen to looking regular & STAYING normal?


Answer:

You probably call for to change your resolution and later click Yes to keep the settings. If you don't click yes it'll revert after 15 second.

The answers post by the user, for information only, RunQA.com does not guarantee the right.




Why is my computer monitor adjectives white ??

whenever i hook up my samsung monitor to the computer, it give my nothing but white. the entire eyeshade is nothing but white muted and i cant do anything . i tried another monitor and it is working perfectly fine ... anyone know what the problem might be ???


Answer:

It's the monitor that have problems then. Maybe LCD board.
***.. u see too much porn
The only piece I can guess is either the settings (like contrast) want adjusting, or the entry is blown.
There is a brightness level on the meu button somewhere on your monitor, possibly it is set up too high, and giving you too much brightness.
i reflect on you should go to best buy and gain it figured out and adjust your blind brightness too


Why is it so tiny?

why have my font size suddenly gone really tiny, this only happen when im on the internet, i can barelly read what it says! please relief im in the middle of nourishing out a survey online and i cant read the questions


Answer:

Well, I'd suggest checking your file size.



On the menu bar, click attitude, then essay size, then set it to majority or medium.
adjust it contained by the options on the zoom on ie 7 or on ie 6 you hold to look around soz i forgot ie 6
if you have internet explorer at the top click landscape hover over text size than click a larger size until u consider its right
When you are browsing.. hold your CTRL button... and try scrolling upwards via your mouse... solved?
u do 1 thing



click on 'view'

next click on 'text size'

there u can choose ur manual as required

i recommend u to choose normal



if this is heplful after plz mail me



let be frnds
If you're using IE7. It happens usually when you roll your mouse controls while keeping the Ctrl key pressed.



For IE7. Click on Page button (on the Extreme departed of the Tabs bar)

Then Click Zoom.

Then Click on 100%



For both IE7 and IE6. View(Alt+v) > Text Size > Medium



For FireFox: View > Text Size > Normal.
You see that you changed the font size. This is a long shot, but try changing the font itself to something similar to Courier New.



And/or - right click - and choose Encoding. Are you using UNICODE?